Anti-static agent SN-Antistatic agent_AILPSS“澳卢实业发展(上海)有限公司

企业概况 / Company Profile

Anti-static agent SN

Anti-static agent

化学组成: 阳离子季铵型表面活性剂 Chemical composition: Cationic quaternary ammonium surfactant

性状： Properties:

外形：棕红色油状粘稠物 Shape: brown-red oil-like viscous material

溶解性能：在室温下易溶于丙酮、苯、正丁醇、氯仿、二甲基甲酰胺，二氧六环、乙二醇、甲基（乙基或丁基），赛璐璐上溶剂及醋酸和水，在50℃时可溶于四氯化碳，二氯乙烷，苯乙烯等。 Solubility: soluble in acetone at room temperature, benzene, butanol, chloroform, dimethylformamide, dioxane, ethylene glycol, methyl (ethyl or butyl), celluloid on the solvent and acetic acid and water, at 50 ℃ soluble in carbon tetrachloride, ethylene dichloride, styrene.

稳定性：对5%的酸碱稳定，当温度提升至180℃以上则要分解。 Stability: stable pH of 5%, when the temperature is raised to 180 ℃ or more will have to break down.

混用性：可以和阳荷性活性剂及非电离活性剂混用，但不宜与阴离子活性剂混用。 Compatibility: can be positive charge of the active agent and non-ionizing activator mix, but should not be mixed with anionic surfactant.

出厂规格：符合下列物理——化学指标： Factory specifications: following physical - chemical indicators:

指标名称： Index name:

外观：棕红色油状粘稠物或膏状物 Appearance: viscous brown oily material or cream

酸碱值：PH=6-8 PH: PH = 6-8

季胺盐含量：52.0-65.0% Quaternary ammonium salt content :52.0-65.0%

用途： Uses:

1. 抗静电剂SN适用于聚酯，聚乙烯醇，聚氧乙烯等合成纤维的纺丝静电 1. Antistatic agent SN suitable for polyester, polyvinyl alcohol, polyoxyethylene such as electrostatic spinning of synthetic fibers

消除剂，面具有优良效果。 Elimination agent, surface with excellent results.

2. 真丝静电消除剂 2. Silk static eliminators

3. 涤纶仿真丝织物碱减量促进剂。 3. From polyester fabric base reduction accelerator.

4. 聚酯聚氧乙烯，聚乙烯薄膜及塑料制品等的静电消除剂具有优良效果。 4. Polyoxyethylene polyester, polyethylene film and plastic products, such as static eliminators with excellent results.

5. 沥青乳化剂 5. Asphalt emulsifier

6. 丁腈橡胶制件纺丝皮辊的消除静电剂。 6. Nitrile roller rubber parts to eliminate static electricity spinning Sipi agent.

7. 阳离子染料聚丙烯晴纤维的染色匀染助剂。 7. Cationic dyes polyacrylonitrile fiber dyeing dyeing auxiliaries.

应用方法： Application Method:

1. 纺织静电消除： 1. Textile Static Elimination:

抗静电剂SN 单独或与其他油剂乳化剂配成水溶液，纤维丝束在上述乳液中经过即可，一般用量0.2-0.5%（对纤维重量计算），即可获得良好的效果。 Antistatic agent SN alone or paired with other oil emulsifier solution, the fiber tow through the emulsion can be in the general amount of 0.2-0.5% (weight of fiber), you can get good results. 例 Cases

如：聚氧乙烯纤维加本品0.2%即可由原来600伏电压降低到20伏左右。 Such as: polyoxyethylene fiber and 0.2% of the product can be reduced from 600 volts to 20 volts.

2. 真丝的静电消除 2. Silk static elimination

抗静电剂SN可单独或与柔软剂同浴配成水溶液，真丝织物在此水溶液中常温浸泡以消除真丝织物的静电一般用量为0.75-1g/l。 Antistatic agent SN alone or paired with the softener bath solution, silk fabric soaked in this solution at room temperature to eliminate static electricity silk fabric dosage is 0.75-1g / l.

3. 涤纶仿真丝织物在碱减量工序中用作促进剂，可以加快碱减量的速度。 3. From polyester fabric used in the base reduction process in the accelerator, can speed up the rate base reduction. 用量根据不同设备，不同织物（纺双绉、纺电力纺、纺真丝）而定。 Depending on the amount of equipment, different fabrics (spun crepe de chine, spinning power spinning, spinning silk) may be.

4. 塑料制品膜的静电消除 4. Electrostatic plastic film

将抗静电剂SN溶于适当的溶剂中，然后与少量的塑料粉混合，干燥后再将此料加入全部塑料粉中，按常法加工，抗静电剂SN 的一般用量0.5-2%，可达到良好的抗静电效果，例如涤纶片录音磁带采用本品0.2%涂敷，经静电测定结果仅20伏，未用本品静电达1200伏。 Antistatic agent will be dissolved in the appropriate solvent SN, and then mixed with a small amount of plastic powder, dry and then add all of this plastic powder material, according to ordinary method to process, the general amount of antistatic agent SN 0.5-2%, can be achieve good anti-static effects, such as polyester film tape coated with 0.2% of the product, measured by the static results of only 20 volts, not the FDA-static up to 1200 volts.

5. 用作沥青沥青乳化剂 5. For asphalt emulsion asphalt

抗静电剂SN 系季胺盐类阳离子表面剂，参考配方：沥青550公斤，水450公斤，抗静电剂SN1-2公斤，沥青乳液的配制，将抗静电剂SN 溶解在80-90℃的水中，加入乳化剂，再将沥青加热到130-150℃，按此比例倒入乳化剂进行乳化即可。 Department of antistatic agent SN cationic surfactant quaternary ammonium salts, reference formula: Asphalt 550 kg, 450 kg of water, antistatic agents SN1-2 kg, the preparation of asphalt emulsion, the antistatic agent SN dissolved in water of 80-90 ℃ added emulsifier, and then asphalt heated to 130-150 ℃, this ratio can be emulsified into the emulsion.

包装及贮运： Packaging and storage:

1．50公斤塑料桶。 1.50 kg plastic bucket.

2． 2. 宜轻装轻卸，贮存于阴凉、干燥、通风的仓库内，密闭保存，贮存期为一年 Should light light unloading, storage in a cool, dry, ventilated warehouse, sealed, stored for one year