adhesion promoters RF-720

 General water and oil paint and ink adhesion promoter

RF-720
一. One. 化学成份:有机硅烷类化合物 Chemical Ingredients: Organic silane compounds
二. II. 物化特性: Physical and chemical properties:

品 名 Name
密 度 Density
25℃,g/cm 3 25 ℃, g / cm 3
折射率 Index of refraction
运动黏度 Kinematic viscosity
mm 2 /s mm 2 / s
活性物 Actives
wt% wt%
外 观 Appearance
RF-720 RF-720
1.045 1.045
1. 4290 1.4290
±0.0050 ± 0.0050
430±2 430 ± 2
≥95 ≥ 95
透明液体 Transparent liquid

以下为典型数据,不代表所售产品的规格范围 The following is typical data, does not mean that the specifications of the range of products sold
主要特性:本产品主要用于水性和油性涂料,油墨的附着力还可改善有机材料和无机材料表面的粘结性能,如玻璃钢中的玻璃纤维和塑料、橡胶、油漆、涂料中的硅质填料等材料的处理,还用于粘结剂中以增加粘结性能,它所适用的树脂包括环氧、酚醛、三聚氰胺、聚硫化物聚氨酯、聚苯乙烯等。 Key Features: This product is mainly used for water-based and oil-based paints, inks can also improve the adhesion of organic materials and bonding properties of the surface of inorganic materials such as glass, steel and glass fiber plastics, rubber, paint, paint the silica filler and other materials processing, is also used to increase the bonding properties of the binder, it applies the resin include epoxy, phenolic, melamine, polyethylene sulfide polyurethane, polystyrene and so on. 1.提高无机颜料、底材和树脂的粘合力,从而提高复合材料的机械强度、电气性能,并且在湿态下有较高的保持率。 1. Enhance the inorganic pigment, and resin substrate adhesion, thereby enhancing the mechanical strength of composite materials, electrical properties, and in the wet state with a higher retention rate. 2.本品作为无机填料表面处理剂,广泛应用于陶土、滑石粉、硅灰石、白炭黑、石英、铝粉、铁粉。 2. The goods as inorganic filler surface treatment agent, widely used in clay, talc, wollastonite, silica, quartz, aluminum powder, iron powder. 3.本品还可改善双组分环氧密封剂的粘合力。 3. The product can also improve the two-component epoxy sealant adhesion. 改善丙烯酸胶乳、密封剂、聚氨酯、环氧涂料的粘合力。 Improve the acrylic latex, sealants, polyurethane, epoxy coating adhesion. 将本品加入树脂、粘结剂或涂料中,然后涂附另一基材上即可。 This product will be added resins, adhesives or paint, then coated substrate to another.
三. III. 应用范围:应用于涂料,油墨,丙烯酸树脂、环氧树脂、聚酯树脂等体系。 Application: used in paint, ink, acrylic resin, epoxy resin, polyester resin system.
四. IV. 推荐用量:按总配方量0.1~1%,具体用量根据试验而定。 Recommended dosage: The total formula by the amount of 0.1 to 1%, the specific amount determined according to the test.
五. Five. 包装规格: 5千克塑桶和25千克塑桶。 Packaging: 5 kg and 25 kg plastic barrel plastic barrel.
六. VI. 贮存方法:放于阴凉干燥处,防止水份污染和尘粒。 Storage: kept in a cool dry place, prevent water pollution and dust.
网站首页 - 企业概况 - 企业风采 - 产品中心 - 新闻动态 - 企业招聘 - 在线留言 - 联系我们
总机:021-67263038 传真:021-67260569
手机:13761045940  13917625983  联系人:王金弟
地址:上海市金山区张堰镇建农路1185号
Copyright © 2017 AILPSS“澳卢实业发展(上海)有限公司 All Rights Reserved.
备案号:沪ICP备17014693号  网站制作公司:郑州伟之琦提供技术支持    营业执照