Antiseptic RF-YN188

Antiseptic

RF-YN188
一、产品介绍 I. Introduction
RF-YN188是本公司最新研制生产的易于以各种比例与水混合的一种新型产品,它可用于所有以水为主要成分的产品体系中,是一种广谱高性能罐内防腐杀菌剂,具有突出的成本效能比的特点,不含溶剂和甲醛,特别适用于非挥发型配方的各种涂料。 RF-YN188 is the latest development and production of easily mixed with water in various proportions, a new product, it can be used for all water system as the main ingredients, is a broad-spectrum antiseptic high-performance tank with outstanding cost performance ratio feature, without solvents and formaldehyde, especially for the various formulations of non-volatile type of paint.
二、应用范围 Second, the application
此产品适用于聚合物分散体、乳胶漆、胶粘剂、颜料分散液、金属切削油以及各类水性涂料、高分子聚合物乳液 This product is suitable for polymer dispersions, latex paint, adhesives, pigment dispersions, metal cutting oil and a variety of water-based paints, emulsion polymers
三、产品特性 Third, the product characteristics
1、最低成本的杀菌剂。 1, the lowest cost of fungicides.
2、极好的相溶性,易于混入树脂乳液和水性漆中。 2, excellent compatibility, easy to mix resin emulsion and water-based paint.
3、在建议使用剂量下无毒,不含有甲醛或甲醛释放物。 3, non-toxic at recommended doses, does not contain formaldehyde or formaldehyde emissions.
4、使用简便,易于加入,在PH值<9.5的范围内都可使用。 4, easy to use, easy to join in the PH value of <9.5 can be used within the scope.
5、较高的活性范围。 5, the higher activity range. 具有抗细菌、酵母菌、真菌和某些藻类的广泛效果。 With anti-bacteria, yeasts, fungi and some algae, a wide range of effects. 最低抑菌浓度(MIC值)的确定,表示实验室条件下在此浓度,试验菌的生长完全被抑制。 Minimum inhibitory concentration (MIC value) determined that this concentration under laboratory conditions, the growth of test bacteria was completely inhibited.
抑菌性能: 试验菌最低抑菌浓度 试验菌最低抑菌浓度 Antibacterial activity: test bacteria strains minimum inhibitory concentration minimum inhibitory concentration test
(MIC值)PPM (MIC值)PPM (MIC value) PPM (MIC value) PPM
肠产气杆菌40 末霉菌85 Intestinal gas production mold end 40 85 Bacillus
大肠杆菌50 黑曲菌 100 Aspergillus niger 100 E. 50
绿脓杆菌60 白假丝酵母150 Pseudomonas aeruginosa, Candida albicans 150 60
枯草杆菌80 发面酵母90 Bacillus subtilis 80 90 baker's yeast
青霉菌145 Penicillium 145
四、添加方法 Fourth, add method
该产品是一种液体产品,可在生产过程中的任何阶段添加到生产用的材料中去,未取得最佳效果,在生产过程中应尽可能早地加入这一产品。 The product is a liquid product in any stage of the production process to produce the materials used to, not get the best results in the production process should be as early as possible to join the product. 如果生产中会出现高温或碱性很强,建议在这些情况得到控制后再加入该产品。 If the production will appear in the high temperature or strong alkaline, it is recommended in these cases under control and then adding the product.
五、建议用量 V. Dosage
对于聚合物乳液、涂料、胶粘剂和其它涂料体系的罐内防腐通常为0.5‰-1.8%。 For the polymer latex, coatings, adhesives and other anti-corrosion coating system of the tank is usually 0.5 ‰ -1.8%.
本品的用量取决于许多因素来达到足够的产品保护,这些因素包括物料体系对微生物降解的敏感度、物料PH值、温度、保存的期限、生产条件以及所要求的最终使用条件,建议通过实验来确实你使用的最佳剂量。 The amount of the product depends on many factors to achieve adequate product protection, these factors include microbial degradation of the material system on the sensitivity of the material PH value, temperature and duration of preservation, production conditions and the required end-use conditions, the proposed experiments to do your best dose to use. 试验应涉及化学相溶性和稳定性的试验。 Chemical compatibility tests should be involved and the stability of the test.
六、运输及安全操作 Sixth, transport and security operations
未经稀释的本品对皮肤稍有刺激性 Undiluted slightly irritating to skin
进行运输时应穿戴橡皮手套、面罩、护目镜和适当的防护服。 The transportation should wear rubber gloves, masks, goggles and appropriate protective clothing.
应避免接触皮肤和吸入喷雾,如有接触,应立即用大量的水冲洗皮肤,至少15分钟,之后若有刺激的感觉,采取外涂乐肤液。 Avoid contact with skin and inhalation of spray, case of contact, immediately flush skin with plenty of water for at least 15 minutes, if after the stimulation feel, skin treated with liquid music.
如眼睛接触,就立即用大量的水冲洗,至少15分钟,并马上就医治疗。 Such as eye contact, immediately flush with plenty of water for at least 15 minutes, and immediately medical treatment.
沾污的衣服必须脱下洗净后方可重新使用。 Contaminated clothing must be washed off before re-use.
使用本品后,用肥皂和清水洗手后再进食或吸烟。 After using this product, wash hands with soap and water before eating or smoking.
七、包装 VII, packaging
本品为25kg或200kg塑桶包装,也可根据用户要求进行包装。 This product is 25kg or 200kg plastic drum can also be packaged according to user requirements. 质保期半年。 Warranty period of six months.
网站首页 - 企业概况 - 企业风采 - 产品中心 - 新闻动态 - 企业招聘 - 在线留言 - 联系我们
总机:021-67263038 传真:021-67260569
手机:13761045940  13917625983  联系人:王金弟
地址:上海市金山区张堰镇建农路1185号
Copyright © 2017 AILPSS“澳卢实业发展(上海)有限公司 All Rights Reserved.
备案号:沪ICP备17014693号  网站制作公司:郑州伟之琦提供技术支持    营业执照